Call 24/7: 07779 836677 / 07448 457247
⚠️
Gearbox Fault Warning:
P0722 and 17106 indicate the Multitronic transmission is not receiving a signal from the G195 output speed sensor. This can cause incorrect ratio control, limp mode, or complete loss of drive.
What Do Audi Fault Codes P0722 & 17106 Mean?
On Audi Multitronic (CVT) gearboxes, fault codes P0722 and 17106 refer to Transmission Output Speed Sensor G195 – No Signal. This sensor monitors output shaft speed, allowing the control unit to calculate ratio changes and vehicle speed accurately.
Common Causes
- Failed G195 output speed sensor
- Internal wiring damage within the gearbox
- Connector corrosion or broken signal line
- Transmission Control Unit (TCU) fault
- Contaminated CVT fluid affecting sensor operation
Typical Symptoms
- PRNDS flashing on the dashboard
- Limp mode or restricted driving
- Speedometer behaving erratically or dropping out
- Delayed engagement or loss of drive
- P0722 / 17106 stored during diagnostics
Our Audi Multitronic Repair Approach
Output speed sensor faults are often misdiagnosed as full gearbox failure. We carry out live data analysis, speed signal comparison, wiring continuity tests, and TCU diagnostics before replacing any major components. In many cases, P0722 / 17106 can be resolved without gearbox replacement.
P0722 or 17106 Showing on Your Audi?
Speak to an Audi Multitronic specialist now.
📞 Call 07779 836677